3M Peltor Tarctical XP Manual De Instrucciones página 154

For the helmet attachment:
(G:1) Remove the hygiene kit and let the foam dry by placing the headset in a position that allows ventilation.
(G:2) Do not store the hearing protectors pressed against the helmet.
For the collapsible headband:
(G:3) Tilt the shells outwards to allow the attenuation cushions and electronics to dry
CARE (H)
CLEANING
Clean/disinfect the cups, headband and ear cushions regularly with soap and warm water.
Note: Do not immerse the cups in water!
REPLACING THE BATTERIES
Undo the screw and open the battery cover. Insert two 1.5-V AA batteries. Check that the positive and negative
terminals on the batteries are correctly positioned (See diagram on cover) Remove the batteries when storing the
hearing protector for a long time. Check the function of the unit after replacing the batteries.
REMOVING/REPLACING THE EAR CUSHIONS
Insert your fingers under the edge of the ear cushion and pull straight out.
Insert the new ear cushion by pressing it in until it snaps in place
CERTIFICATE ATEX (I)
SPARE PARTS (J)
Hygiene kit – HY79
Easy-to-replace hygiene kit consisting of two attenuation cushions and snap-in ear cushions. Replace at least twice
a year to ensure constant attenuation, hygiene and comfort.
WIND PROTECTION – M41/2
Wind protection for the microphones. Packages of 1 pairs.
ACCESSORIES Ex approved (L)
Ex approved adaptors for use with Ex approved headsets -07
FL52**
Ex approved connector cords for use with Ex approved standard headset
FL6H 3.5 mm mono connector
FL6M 2.5 mm mono connector
FL6N 3.5 mm stereo connector
Connector cords of cold and wear-resistant polyurethane for connection to a com radio etc. Length 110 cm.
MT91-50 Throat microphone
154