Generator Maintenance - Cebora PLASMA PROF 123 ACC Manual De Instrucciones

Equipo de corte en plasma
Ocultar thumbs Ver también para PLASMA PROF 123 ACC:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
• Always replace any damaged parts of the machine
or the welding torch with original parts.
• Use torches CEBORA Type CP 161 only.
8 MAINTENANCE
Any maintenance operation must be carried out by
qualifi ed personnel in compliance with standard CEI
26-29 (IEC 60974-4).

8.1 GENERATOR MAINTENANCE

In the case of maintenance inside the machine, make
sure that the switch A is in position "O" and that the
power cord is disconnected from the mains.
Even though the machine is equipped with an automatic
condensation drainage device that is tripped each time
the air supply is closed, it is good practice to periodically
make sure that there is no condensation accumulated in
the water trap J (fi g.1).
It is also necessary to periodically clean the interior of the
machine from the accumulated metal dust, using com-
pressed air.
8.2 PRECAUTIONS AFTER REPAIRS.
After making repairs, take care to organize the wiring so
that there is secure insulation between the primary and
secondary sides of the machine. Do not allow the wires
to come into contact with moving parts or those that heat
up during operation. Reassemble all clamps as they were
on the original machine, to prevent a connection from
occurring between the primary and secondary circuits
should a wire accidentally break or be disconnected.
Also mount the screws with geared washers as on the
original machine.
15
Tabla de contenido
loading

Este manual también es adecuado para:

956

Tabla de contenido