Safety And Notices; Safety Instructions - Schellenberg PREMIUM 20506 Manual Del Usuario

SAFETy AND NOTICES

Dear customers,
please completely read this instruction manual before the installation and commissioning. Observe all safety
instructions before you begin executing any work. Keep the instruction manual stored at hand and advise each user
about possible dangers that are related to this product. In case of a change in ownership pass on the instruction
manual to the new owner. In case of damages which are caused by misuse or improper installation the warranty and any
warranty claim will be void.

SAFETy INSTRUCTIONS

There is danger to life from electric shock!
Before working on electrical equipment, the facility must be de-energized. This also applies for the maintenance
and repair of the motorized awning system. Work on electrical installations may only be performed by licensed
electrical professionals. The provisions of the local electric utility company as well as all applicable standards and
regulations for electrical installations must be complied with.
Before working on roller shutter systems, the shutters must be secured against a self-actuated falling down.
Only use the tubular motor in dry rooms (protection class IP44).
The tubular motors become very hot during normal operation. Caution, risk of injury!
The connecting cable of the tubular motors may not be installed outdoors.
The tubular motor and the packaging are not toys. Keep children away from them. There is a danger of injury and
suffocation.
During the adjustment process third parties must be kept away from the shutter system.
The tubular motors may not be opened.
The tubular motors are maintenance free and do not require any special care.
The cover of the shutter box should be installed in such a way, that an access is possible at any time.
Inspect the tubular motor prior to installation for damage and completeness of the accessories.
The tensile load and the dimensioning of the tubular motor must be adapted to the shutter system. The permitted load of the
tubular motor may not be exceeded.
The tubular motors are designed for short-term operation with a duty cycle of 4 minutes. In case of overheating due to long
operating times or a too high tensile load, the motor will stop. After a cooling period of at least 15 minutes, the tubular motor
will be ready for operation again.
Check the shutter system regularly for smooth running and for freezing in winter.
If you have technical questions about your shutter system, please contact our customer service.
During operation, small variations in the end-position can occur due to temperature differences during the winter and
summer. If necessary, a further fine tuning of the final positions may be necessary. Equalize length tolerances of the octagonal shaft with a suitable roller sleeve [item-no. 80100 (MINI), item-no. 80200
(MAXI)].
The roller sleeve must be inserted at least 60 mm deep into the octagonal shaft (page 194). It may not touch the tube motor
in the octagonal shaft or obstruct the motion.
INTENDED USE
The tubular motors are designed exclusively for use in roller shutter systems.
The tubular motors may only be used in properly assembled roller shutter systems.
The roller shutter systems must be in a flawless condition.
Defects of the roller shutter systems must be resolved before the installation of tubular motors, and damaged parts must be
replaced.
Using the tubular motor for purposes other than those mentioned above is considered contrary to its designated use.
The Alfred Schellenberg GmbH shall not be liable for any consequential damage, property damage and personal injury due
to improper use.
11
GB