General System Functions; Sending Commands; Receiving Commands; Active Lock/Arm And Unlock/Disarm - Firstech, LLC. 2W902R-SP Manual De Usuario

2.5 seconds
Half second
Half second
Half second
2.5 seconds
If you would like additional information on the functionality of your 1 Way companion remote, please visit
the support page at www.compustar.com
The remote transmitter functions are predetermined and programmed from the factory. The five button
configuration allows for many functions to be performed through a series of tapping and/or holding
buttons.

Sending Commands

When in range and a command has been sent the remote will beep and unique LED will flash blue or red.
For example, to send a remote start command from the pager, hold the Key/Start
seconds. The remote will beep confirming the command has been sent and that the remote is in range.
Once the vehicle has successfully remote started, the remote will receive a three beep and LED
command indicating the vehicle is running.

Receiving Commands

The remote pager will receive commands indicating the status of the vehicle, confirmation of sending
commands and remote start notifications. For example, after sending the lock command, the pager will
receive LED and chirp signals confirming that the vehicle has been successfully locked/armed. To see if
your pager is in range, tap the
confirmation then it is in range.

Active Lock/Arm and Unlock/Disarm

Tap the Lock button for a half second to lock/arm your vehicle. Tap the Unlock
to unlock/disarm your vehicle. If equipped this will also activate your starter kill and anti grind
feature. Also you will not be able to start your vehicle with the key until unlock/disarm.
IMPORTANT: If the alarm has been triggered (Siren is sounding, parking lights flashing, and horn
honking), you must wait until the remote pager has been paged before disarming the alarm – the first
button tap will shut off the alarm and the second will unlock/disarm the system.

Passive Lock/Arm

The system can be configured to passively lock and arm the vehicle. Put the system in
passive by tapping the Trunk + Key Start buttons
The remote will beep once and the LEDs will illuminate to indicate the system is in passive lock and
no Option programming menu 2 - Installers Only.
no Activates passive arming (vehicle will arm/lock 30 seconds after the vehicle is disarmed)
Activates timer start mode. Timer start mode has multiple programmable settings:
yes
duration settings, temperature settings and self start settings.
Activates the built in Turbo Timer function. Additional installation is required when using
yes
this feature on automatic transmission vehicle's.
no Car Check / Secure Auxiliary
to download the full user manual.

General System Functions

button for a half second – if the remote receives an audible and LED
8
button for 2.5
button
button for a half second.