Remote Start Error Diagnostic; Alarm Diagnostic - Firstech, LLC. 2W902R-SP Manual De Usuario

STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the
Acc & On positions) five times within 7 seconds. The vehicle's parking lights will flash once with the
successful completion of this step.
STEP 2: Within 2 seconds after cycling the ignition for the 5
remotes or the (lock) button on 1 way remotes for a half second. The parking lights will flash once to
confirm the transmitter has been coded.
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those three flashes the parking lights will flash again corresponding to the error table.
Number of
Parking Light
Flashes
1
2
3
5
6
7
8
9
10
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us
directly.
While the alarm is armed, the LED will blink slowly. While the siren is going off, the LED will indicate
which specific zone was triggered.
Priority
Door/Hood/Trunk/Key Triggered
1
nd
2 2 Shock Triggered
3 Optional Sensor Triggered
Exiting Programming: Programming is a timed sequence. The parking
lights will flash twice signaling the end of programming mode.
Programming Multiple Remotes: After the confirmation flash given in
step 2, code additional remotes by pressing button
remotes or the (lock) button on 1 way remotes. The parking lights will
flash once confirming each additional remote. All systems can
recognize up to three remotes.

Remote Start Error Diagnostic

Remote Start Error
Motor running
Key in ignition on position
Door open (manual transmission only)
Foot brake on
Hood open
Reservation off (manual transmission only)
Tach or voltage sensing failure
DAS sensor movement
System is in Valet Mode

Alarm Diagnostic

Situation
th
time, tap the Lock button
LED On Duty
2 flash, rest, then repeat
3 flash, rest, then repeat
4 flash, rest, then repeat
16
on 2 way
on 2 way