Troubleshooting - Bresser GPS 7x50 Instrucciones De Uso

DISPLAY OF RECORDED LATITUDE AND LONGITUDE DATA
1. Press the [POWER] button to switch on. The binoculars will be activated in the "Latitude / Lon-
gitude" mode.
2. Press the [SAVE] button for a short time with the "Latitude / Longitude Mode" displayed.
3. With every short press of the [SAVE] button, the fi ve recorded places will blink in the order of
No. 1 to No. 5.
4. By pressing the [SAVE] button long, the display will return to the "Latitude / Longitude" display
screen.
• The display will automatically change to the "Latitude / Longitude" mode after 30 seconds.
Registration number
Old
CLEARING ALL RECORDED LATITUDE AND LONGITUDE DATA
2.
4.
• Please note that the stored "latitude / longitude" data will be all cleared.
• Please note that you cannot clear data individually.
• Please take extra care when deleting data. The data cannot be restored once cleared.
• Please transcribe data in a notebook as needed, before deleting the data.

TROUBLESHOOTING

TROUBLE
The binoculars do not
switch on.
All the recorded latitude / longitude data can be cleared.
1. Press the [POWER] button to switch on. The binoculars will be
activated in the "Latitude / Longitude" mode.
2. Press the [SAVE] button for a short time with the "Latitude /
Longitude Mode" to display the recorded latitude / longitude
data.
3. Press the [MODE] button and the [SAVE] button simultane-
ously for more than 2 seconds.
4. All the data will be deleted with "CLEAR" indicated.
5. The display will automatically return to the "Latitude / Longi-
tude" display in 3 seconds.
LIKELY CAUSE
The remaining battery level may
be too low.
Battery Cap loose.
Batteries may have been set in
the wrong + - position.
- 20 -
SOLUTION
Please replace the used
batteries with new ones.
Tighten Cap.
Please reinstall the batteries
in the proper position in
accordance with the "Battery
Installation" segment of this
manual.
New