Bresser GPS 7x50 Instrucciones De Uso página 18

Latitude
Longitude
The GPS Binoculars displays the latitude/longitude in the order of degree, minute, and second,
with the second indicated to the fi rst decimal point (0.1 seconds).
• The positioning time may be prolonged even at a vantage point in the factory default setting or
battery replacement condition.
• GPS signals are very weak in some locations, GPS signals may show signifi cant errors or may
have diffi culty indicating the present location under such conditions as within a room, vehicle or
airplane, including near a window, between buildings, in a small alley, underground, in a tunnel,
under an elevated highway or high-voltage power line, in a forest, and after the passage of a large
truck or bus. Such conditions are not abnormal for the product. For full GPS functioning, it should
be used in open air, away from tall buildings or heavy forests, which can block much of the signal.
• The positioning time may vary according to the reception environment. The binoculars may take
a long time to receive satellite data in an open-air narrow area such as between buildings.
• Do not touch the GPS receiver (around the part marked as GPS Digital Compass) with your
fi ngers and do not cover it with any metal, cloth, or plastic barrier).
• Please note that the latitude/longitude in the previous position will be indicated while updating
the GPS data.
DISPLAY OF DATE / TIME
1. Press the [POWER] button to switch on. The binoculars will be activated in the "Latitude/Longi-
tude Display Mode".
2. Press the [MODE] button once, and the mode will change to the "Date / Time Mode".
3. Press the [MODE] button again, and the mode will change to the "Latitude/Longitude Mode".
1.
ADJUSTMENT OF TIME DIFFERENCE
The time difference will be adjusted according to the UTC (Coordinated Universal Time) with 39
patterns of time difference incorporated into it. The GPS Binoculars Signal is available all over the
world except for some isolated islands. (Please note that the binoculars do not support daylight
saving time.) The time zone is set at UTC+00.00 as the factory default and needs to be reset ac-
cording to the current location.
Latitude (N/S): The latitude is divided into zones 90 degrees
south and north of the equator, which is defi ned as 0 degrees
latitude. The north of the equator is indicated as the north latitude
(N) and the south of the equator is indicated as the south latitude
(S) respectively.
Longitude (E/W): The longitude is divided into zones 180 de-
grees south and north of the prime meridian (Royal Greenwich Ob-
servatory) defi ned as 0 degrees longitude. The east of the prime
meridian is indicated as the east longitude (E) and the west of the
prime meridian is indicated as the west longitude (W) respectively.
2.
- 18 -