Important Safety Instructions - Tripp-Lite SmartPro 1U Rackmount El Manual Del Propietario

200210187 Smart 700-1000 RM1U Owner's Manual 93-2102.qxd

Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains important instructions that should be followed during the installation,
operation and storage of all Tripp Lite UPS Systems. Failure to heed these warnings will void
your warranty.
UPS Location Warnings
• Install your UPS indoors, away from excess moisture or heat, dust or direct sunlight.
• For best performance, the ambient temperature near your UPS should be between 0º C
and 40° C (between 32° F and 104° F).
• Leave adequate space around all sides of the UPS for proper ventilation. Do not obstruct its
vents or fan openings.
UPS Connection Warnings
• The UPS contains its own energy source (battery). The output terminals may be live even
when the UPS is not connected to an AC supply.
• Connect your UPS directly to a properly grounded AC power outlet. Do not plug your UPS
into itself; this may damage the UPS.
• Do not modify the UPS's plug. Do not use adapters that eliminate the UPS's connection to
ground. Do not use extension cords between the UPS and the AC outlet. If necessary, a Tripp
Lite surge suppressor may be used between the UPS and the AC outlet.
• If you are connecting your UPS to a motor-powered AC generator, the generator must provide
filtered, frequency-regulated computer-grade output. Connecting your UPS to a generator will
void its Ultimate Lifetime Insurance.
Equipment Connection Warnings
• Do not use Tripp Lite UPS Systems for life support applications in which a malfunction or
failure of a Tripp Lite UPS System could cause failure or significantly alter the performance
of a life-support device.
• Do not connect surge suppressors or extension cords to the output of your UPS. This may
damage your UPS and will void both the surge suppressor and UPS warranties.
Battery Warnings
• Except for battery replacement, your UPS does not require routine maintenance. Do not open
your UPS for any reason. There are no user-serviceable parts inside.
• Battery replacement must be performed by qualified service personnel. Because the batteries
present a risk of electrical shock and burn from high short-circuit current, qualified service
personnel should observe proper precautions: make sure the UPS is not in INVERT mode
before performing battery replacement. Use tools with insulated handles and replace the
existing batteries with the same number and type of new batteries (Sealed Lead-Acid). Do not
open the batteries. Do not short or bridge the battery terminals with any object.
• Do not operate UPS without batteries except during hot-swap battery replacement.
• The UPS batteries are recyclable. Refer to local codes for disposal requirements or in the
USA only call 1-800-SAV-LEAD (1-800-728-5323) for complete recycling information.
Do not dispose of the batteries in a fire.
• Do not attempt to add external battery packs.
11/1/2002
2
9:50 AM Page 2