Service And Maintenance - marklin LGB 26841 Manual Del Usuario

SERVICE
Lubrication
The axle bearings and the side rod bearings should be lubri-
cated occasionally with a small amount of Märklin-Oil (7149).
Replacing the light bulbs
Lights (front, upper rear): Pull the lantern housing away from
the model. Remove and replace the bulb. Reassemble.
Lights (lower rear): Remove the ring around the lantern
lens. Carefully pry the lens away from the lantern. Using
tweezers, remove and replace the bulb. Reassemble.
Cab light: Using tweezers, remove and replace the bulb.
Replacing the traction tire
- Remove the screw in front of the rear gearbox.
- Remove the screw on the rear coupler.
- Remove the hex screw on the rear drive rod and take the
drive rod off the wheel.
- Pull the rear gearbox out of the sideframe.
- Use a small, straight-blade screwdriver to pry the old
traction tire out of the wheel groove.
- Use a small, straight-blade screwdriver to gently pry the
new traction tire into the wheel groove.
- Make sure that the traction tire is seated properly in the
wheel groove.
- Reassemble.
Replacing the smoke generator
- Pull the safety cover out of the smoke stack (Fig. 4).
- Use pliers or tweezers to pull the old smoke generator out
of the stack.
- Cut the wires to the old generator and attach them to the
replacement generator.
- Insulate the connections and push the replacement
generator into the stack (Fig. 5).
- Reassemble.
7