Makita 6904VH Manual De Instrucciones página 5

change lever is slid fully to the desired side. Select the
speed optimum for your job.
CAUTION:
• Do not use the speed change lever while the tool is
running. The tool may be damaged.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and incon-
sistent fastening torque and/or damage to the bolt or nut.
Installing or removing socket
1
2
To install the socket, push it onto the anvil of the tool until
it locks into place.
To remove the socket, simply pull it off.
OPERATION
002335
1. Socket
2. Anvil
007444
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Standard bolt
N.m
(ft.lbs)
M16X50 (5/8" X 2") at high speed
140
(101)
120
(87)
100
(72)
80
(58)
60
(43)
M12X50 (1/2" X 2") at high speed
40
M12X50 (1/2" X 2") at low speed
(29)
20 M10X50 (3/8" X 2") at low speed
(14)
M10X50 (3/8" X 2") at high speed
0 1
High tensile bolt
N.m
260
(188)
240
(174)
220
M16X50 (5/8" X 2") at high speed
(159)
200
(145)
180
(130)
160
(116)
140
(101)
120
(87)
100
(72)
80
(58)
60
(43)
M10X50 (3/8" X 2") at low speed
40
(29)
20
M10X50 (3/8" X 2") at high speed
(14)
0 1 2 3
Fastening time
Standard bolt
N.m
(ft.lbs)
200
(144)
150
(108)
100
(72)
50
(36)
0 0.5
5
For 6904VH
M16 (5/8")
M16X50 (5/8" X 2") at low speed
M12 (1/2")
M10 (3/8")
2 3 (S)
Fastening time
For 6904VH
M16 (5/8")
M12X50 (1/2" X 2") at high speed
M16X50 (5/8" X 2") at low speed
M12 (1/2")
M12X50 (1/2" X 2") at low speed
M10 (3/8")
4 5 6 (S)
M20 (3/4")
M20X50
(3/4" X 2")
M16X50
(5/8" X 2")
M16 (5/8")
M12X50
(7/16" X 2")
M12 (7/16")
1 1.5
Fastening time
(S)
002346
002347
002349
For 6905H