Electrical Installation - Johnson Pump UltimaSwitch Manual De Instrucciones

• The bottom of the UltimaSwitch™ can be mounted higher
than the pump, but never lower than the base of the pump.
Test
• To test the functionality of the UltimaSwitch™ hold two
fingers over the raised circular areas on the side for ap-
proximately 10 seconds. If the wiring is correct the bilge
pump will activate. If you remove a finger from the top
circle the pump should still be on. On removal of both
fingers from the circles, the bilge pump should no longer
run after a short delay.
• Make sure to test the UltimaSwitch™ with water in the
bilge of the vessel to re-affirm that the pump will turn on
and off properly.

electrical installation

See wiring diagram on page -5
Warranty
Your UltimaSwitch™ is covered by a 3-year limited war-
ranty
8