Troubleshooting Table - Mellerware ICE MASTER 150W Manual De Instrucciones

Troubleshooting table

PROBLEM
"Add Water" indicator is on.
"Ice Full" indicator is on.
Ice cubes stick together.
Ice making cycle is normal but no
ice formed.
POSSIBLE CAUSE
Little water in water reservoir.The
ice basket is full.
The ice making cycle is too long.
Water temperature in inner tank
is too low.
Room or water temperature in
inner tank is too high.
Refrigerant in cooling system may
be leaking.
Pipe in the cooling system could
be blocked.
SOLUTION
Switch off the ice maker, fill water,
and press "ON/OFF" button again
to restart the unit.
Remove ice from ice basket.
Replace the empty ice basket
immediately to prevent the next
batch ice bullets from falling into
the water reservoir.
Stop the ice maker, and restart it
when the ice blocks melt. Select
the small size ice cube selection.
Replace the water. Temperature
of water recommended at 8-22
C. The room temperature should
be 10-35 C, water temperature
should be 8-22 C.
Return product to service center
to be verified by a qualified
technician.
Return product to service center
to be verified by a qualified
technician.