Automatic Cleaning; Troubleshooting Table - Mellerware ICE MASTER 110W Manual De Instrucciones

sensor malfunction. If the unit doesn't stop, then move
the unit where there's no sunlight.
3.2.10. Change water in the reservoir every 24 hours
for hygiene purposes. If the unit isn't being used, drain
all the wate and dry the tank.

3.3. Automatic Cleaning:

3.3.1. When the machine is in standby mode, press the
"CLEAN" button. You will then see 30 on the display,
which means 30 minutes for cleaning. After 30 minutes
the machine will be on standby mode again.
3.3.2. If you want to stop the cleaning process, press
the "CLEAN" or the "ON/OFF" button. During the
cleaning, auxiliary tools, like neutral or food hygiene
cleaners, can be used.
3.4. Timer:
3.4.1. Timing setting range: 1-24 hour. The default
timer is 1 hour.
3.4.2. Timed shutdown: the machine can be set to shut
down during the ice making process.
3.4.3. Timed start-up: When the machine is in standby
mode, a start time can be set.
3.4.4. How to set the timer.
3.4.4.1. Press the "TIMER" on the operation panel, it
will display 01H for the default timing, and the "H" will
be flashing. Then adjust the timing by pressing the "L"
for increasing 01H or "S" for decreasing, based on your
needs.

Troubleshooting table

PROBLEM
"Add Water" indicator is on.
"Ice Full" indicator is on.
Ice cubes stick together.
Ice making cycle is normal but no
ice formed.
3.4.4.2. After 5 seconds the "H" will stop flashing and
the light will turn on, this means the setting is complete.
3.4.4.3. The "xxH" in the display indicates that the
machine currently has a timing function. After the
countdown is at zero, the machine will enter the mode
you need.
3.4.5. How to cancel the timer.
3.4.5.1. If the machine is timed (xxH on the screen), press "TIMER", and the "H" will flash on the screen,
press "TIMER" again. The timer will be cancelled.
You can also press the "ON/OFF" button for timing to
cancel.
4. Recycling
4.1. These electrical products, cables, batteries,
packaging, and the manual, should not be mixed
with general household waste. For proper recycling,
please take these products to your nearest Creative
Housewares office where they will be accepted for
recycling free of charge.
4.2. Alternatively, please contact your local authority
or household waste disposal service for further details
of your nearest designated collection point. Correct
product disposal saves resources and prevents
negative effects on human health and the environment.
POSSIBLE CAUSE
Lack of water.
Ice is full in basket.
The ice making cycle is too long.
Water temperature in inner tank is
too low.
Room temperatukre or water
temperature in inner tank is too
high.
Refrigerant in cooling system leaks.
Pipe in the cooling system is
blocked.
SOLUTION
Stop the ice maker, fill water, and
press "ON/OFF" button again to
restart the unit.
Remove ice from ice basket.
Continuously press "Select" button
for 5 seconds, the unit could make
ice 10 cycles even if "ice" indicator
is on.
Stop the ice maker, and restart it
when the ice blocks melt. Select
the small size ice cube selection.
Replace the water. Temperature of
water recommended at 8-32°C.
The room temperature should be
10-43°C, water temperature should
be 8-32°C.
Verify by a qualified technician.
Verify by a qualified technician.