Mellerware ICE MASTER 150W Manual De Instrucciones página 4

Step 4
If indicator ADD WATER is red with 'DI' noise,then take
out the basket,then add water as per step 1, then press
ON/OFF to
restart the ice maker
Note: If no water is pumped up to the water tray over
two cycles but the water in water tank is enough, then
please move the unit ahead a little,then remove the
silicon stopper,and let several drops water run out.
Step 5
If indicator ICE FULL is in red with 'DI DI' noise,please
take out the ice with the scoop.
Note: When the ice collecting tray is full please remove
the ice immediately, Do not allow the ice collecting tray
to overfill.
Step 6
Press ON/OFF button to stop the machine.
3.4 Once you have finished using the appliance:
3.4.1. Allow appliance to cool down.
3.4.2. Unplug the appliance from the mains power
supply.
3.4.3. Clean the appliance as described in the cleaning
section.
4. Cleaning and Maintenance
Clean the inner liner, ice collecting tray, water box,
ice shovel and evaporator frequently. When cleaning,
unplug the unit and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and
the outside surface of the ice maker. Do not spray ice
maker with chemicals or diluted agents such as acids,
gasoline or oil based products. Rinse thoroughly before
starting.
•Keep ventilation openings in the appliance enclosure,
or in the built-in structure, clear of obstruction. Do not
use mechanical devices or other means to accelerate
the defrosting process, other than those recommended
by the manufacturer.
•If the icemaker is reused after a long time, the water
pump may not pump sufficient water due to an air
block, the deficient water indicator turns on in this case.
•To correct this press the ON/OFF button again, then
the icemaker will work normally.
•To ensure the cleanliness of the ice cubes, water in
the water reservoir should be replaced every 24 hours.
•If the compressor stops for any reason such as water
shortage, too much Ice, power off, etc... Do not start
the system right away, wait 3 minutes, and then re-start
the ice maker.
•Always use fresh water before starting ice production
either at initial installation or after a long shut-off period.
5. Anomalies and repair
5.1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
5.2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
6. Troubleshooting
6.1. Please note, if a power failure occurs due to
disconnection of the power cord, or the off power
button has been pushed off during an ice making cycle,
small ice chips may form and lodge in the automatic
shovel causing it to jam. If this occurs, the ice chips
may be removed by disconnecting the power cord and
gently pushing the shovel to the rear of the cabinet and
removing the ice chips, then restarting.
6.2. Please restart the ice maker by pressing "OFF"
and then "ON". If the ice shovel does not push the ice
into the ice collector after the formed ice drops from
the evaporator finger while at the same time the M light
is on, check to see if the water tray is horizontal or
balanced. If not then adjust by pressing the ice shovel
lightly with your finger. Then restart the ice maker.
WARNING
If the power cord is damaged; it must be replaced
by the manufacturer, its service agent or a similarly
qualified person in order to avoid a hazard.
Fill with potable water only.
It is normal for the compressor and condenser surface
to reach temperatures between 70°C and 90°C during
operation and surrounding areas may be very hot.
Due to fast freezing, ice cubes may appear "Cloudy".
This is air trapped in the water and will not affect quality
or taste of ice.
This appliance is not intended for use by
persons (including children) with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge unless they have
been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Do not immerse in water.
Correct Disposal of this product - This marking
indicates that this product should not be disposed with
other household wastes. To prevent possible harm to
the environment or human health from uncontrolled
waste disposal,recycle it responsibly to promote the
sustainable reuse of material resources.