Declaration Of Conformity - Bosch PSB 530 RA Manual Original

20 | English

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
17.01.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Before any work on the machine itself, pull
the mains plug.
Dust/Chip Extraction (PSB 530 RA/
PSB 650 RA) (see figure A)
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in con-
nection with wood-treatment additives (chro-
mate, wood preservative). Materials contain-
ing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your coun-
try for the materials to be worked.
2 609 002 371 | (21.1.08)
Dr. Eckerhard Strötgen
Head of Product
Certification
Use the dust/chip extraction only when
working concrete, brick and brickwork.
Wood or plastic chips can easily lead to clog-
ging.
WARNING Fire hazard! Do not work metallic
materials with the extraction device mount-
ed. Hot metal chips can ignite parts of the ex-
traction device.
To achieve optimum extraction results, please
observe the following notes:
– Pay attention that the extraction device faces
flush against the workpiece or the wall. This
also makes drilling at a right angle easier.
– When using the extraction device, always
work with the maximum speed.
– After reaching the desired drilling depth, pull
the drill bit out of the drill hole first and then
switch off the impact drill.
– Check the condition of the filter element 19
regularly. Replace a damaged filter element
immediately.
– The dust protection ring 16 can wear, espe-
cially when working with large drill-bit diame-
ters. Replace the dust protection ring when
worn/damaged.
Mounting the Extraction Device
Guide the extraction device 9 from the front to-
ward the bottom side of the impact drill. Pay at-
tention that the extraction device 9 faces flush
against the casing and that it is locked.
Bosch Power Tools