Conceptronic CSATAC2 Guía De Instalación Rápida página 6

ENGLISH
2. Connect the "Y" split cable to the adapter (Please refer to figure 2)
3. Connect the Ultra ATA hard disk drive to the adapter (Please refer to figure 3
and 4)
4. Connect the other end of the Serial ATA cable to the Serial ATA port on the
Serial ATA host adapter
5. Connect the other end of the "Y" split power cable to the power source.
6. Do not forget to connect the power cable to the hard disk.
Note: No driver is needed to install the Serial ATA-to-Ultra ATA Adapter. It only
acts as a bridge adapter between Serial ATA and Ultra ATA interface.
Figure 2
Figure 3 Figure 4
6