Vortice VORT HR 300 NETI Manual De Instrucciones página 42

ENGLISH
"Speed Adjustment Menu" page
Select "Speed" from the "Installer Operations menu" to access the "Speed Adjustment Menu."
FAN SPEED
FAN1 MIN
FAN1 MAX
FAN2 MIN
FAN2 MAX
Motor speed can be adjusted depending on the system flow rates, selecting:
FAN1 = (A) Clean air supply in room
"Modbus ID" page
If more than one remote control HMI are installed , it is necessary to set the value of them like shown here below.
1. Change the "MBUS ID" so that it is different than 1 and also different from the value of other remote controls, for
example , insert the number 2 and press √
2. Disconnect the HRU from the electrical grid
3. Connect the other HMI remote control
4. Reconnect the HRU to the electrical grid
5. Wait 30sec - 1min : the led with the symbol "√" will start flashing.
6. At the end of the process the HRU will go back to normal functioning.
7. Repeat points from 2 to 6 for each HMI remote control, remember always to set a different MBUS ID for each HMI remote
control.
NOTA: after the first star up with the second remote HMI control connected it is necesary to disconnect the machine from electricity
and then connecting it back.
"Alarms" page
Access the "Alarms" page only if the machine detects one of the problems detailed below:
• Pre-alarm: Filter check
• Alarm : Filters to be replaced
• Alarm : No Frost - Wait an hour
• Alarm : Ext Probe fault
• Alarm : Int Probe fault
• Alarm : Exh Probe fault
Alarm with machine block:
Alarm with machine block:
In the presence of alarms: select the "Alarms" line and press the []
The dialogue window opens with instructions on how to resolve the problem.
Warning:
!
After 2 minutes with no keys being pressed, the display returns to the "Home" page without saving any
changes.
FAN 1 MIN = Minimum speed
FAN 1 MAX = Maximum speed
the messages "Alarm!" and "Block!" appear alternately on the "HOME" page.
the messages "Alarm!" and "Block!" appear alternately on the "HOME" page.
USE MENU
ALARM
SETUP
INFO
[ ▲ ]
FAN2 = (D) Stale air supply toward outside
occurs without blocking the machine
occurs without blocking the machine.
occurs with machine block.
occurs without blocking the machine (No Frost, Bypass: deactivated);
occurs without blocking the machine (Bypass: deactivated).
occurs without blocking the machine (No Frost deactivated).
MAIN MENU
060
FAN 2 MIN = Minimum speed
FAN 2 MAX = Maximum speed
key on the "Main menu" page.
[ ▲ ]
[ ]
[ ▲ ]
42