Idiomas disponibles
Idiomas disponibles
P R E PARING THE RECEIVER
REMOVING THE RECEIVER COVER
Refer to Figure 5.
1. Gently push up on the chimes' cover
to disengage the cover from the base
and pull cover away from base.
2. Set chime cover aside.
MOUNTING THE
CHIME BASE
Refer to Figure 6.
1. Select the desired
mounting location. This
location should be at least
1 foot away from metal
objects and within
100 feet (30 meters) of
the chime transmitter.
2. Drill one
3
/
" hole at the
1 6
desired mounting height.
3. Insert the plastic anchor
into the
/
" hole.
3
1 6
4. Drive the upper screw into the plastic anchor until the head of
the screw extends approximately
5. Place the keyhole slot in the receiver base over
the screw head. Slide the Receiver down to secure it.
6. Level the chime receiver on the mounting surface.
7. Mark the mounting surface with a pencil at the center of the
oval hole in the bottom of the receiver base.
8. Gently remove the chime base from the mounting surface
and drill one
/
" hole at the previously marked area.
3
1 6
9. Insert the plastic anchor into the
chime receiver.
10. Insert the screw through the chime base into the plastic
anchor. Level chime base and tighten screw.
RECEIVER SECURITY CODING
Refer to Figure 7.
Changing the
Security code is not
necessary unless
you have changed
the security code in
the pushbutton.
Both the
pushbutton and
receiver codes
POWER
must match.
SWITCH
1. Remove the
same jumpers
in the receiver
as in the
3 – "D" SIZE
BATTERIES
p u s h b u t t o n .
I N S TA L L I N G
B ATTERIES IN RECEIVER
Refer to Figure 7.
Refer to Figure 7 for placement and polarity of batteries. The
NuTone wireless chime requires three "D" size alkaline batteries.
ADJUSTING THE RECEIVER VOLUME
Refer to Figure 7.
1. Slide power switch to the ON position.
2. Press pushbutton. The red light will light.
3. Adjust volume control to desired sound level. To increase
volume, turn the control clockwise.
FIGURE 5
1/8"
CHIME
RECEIVER
KEYHOLE
SLOT
FIGURE 6
1
/
" from the mounting surface.
8
3
/
" hole and remount the
1 6
FIGURE 7
AT TACHING THE RECEIVER COVER
Position chime cover over chime base. Align the mounting tab on cover
with slot in top of base.
TROUBLESHOOTING GUIDE
P R O B L E M
1. Chime does not sound.
2. Chime changes tone.
3. Chime looses volume.
4. Chime is activated by another
wireless device.
5. When pushbutton is pressed, the
incorrect chime sound is heard.
Product specifications subject to change without notice.
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in China, Rev. 9/06, Part No. 85719
S O L U T I O N
Check batteries and polarity.
Make sure receiver or pushbutton
is not located on metal surface.
Check receiver and pushbutton security
code. These codes must match.
Check batteries in receiver.
Check batteries in receiver.
Change the security code in the pushbutton
and receiver. These codes must match.
Check the sound code jumpers
in the pushbutton.
