NuTone LA600WH Instrucciones De Instalación Y Operación

LA600WH WIRED /
WIRELESS DOOR CHIME
To register this product, visit: www.nutone.com
THIS PACKAGE INCLUDES:
n Wired / Wireless Door Chime with MP3 upload capability
n Decorative White Chime Cover
n USB Cable
n Mounting Hardware
n Pushbutton Diode (required for wired installation)
Door chime comes with eight pre-loaded sounds. Prior to installation,
upload desired MP3 sound files.
1. Remove chime cover (B) from chime base (A). You may need to
insert a finger into the large hole on the back of the chime base.
(Figure 1)
A
UPLOAD MP3 TUNES
1. Insert a USB Mini cable end into the doorbell mechanism USB jack
(C). (Figure 1)
2. Insert the remaining larger USB cable end into a USB port on your
computer.
3. On your WINDOWS computer,
• Select "Start" in the bottom corner of your Desktop.
• Select "My Computer"
• Select the new device detected. (The drive "D:" , "E:" , etc. will vary
from computer to computer).
• Select the device.
• You will now see a window that contains several mp3 files. These
are the tunes that are pre-installed on your doorbell mechanism.
• Search your computer for other mp3 songs that you wish to play
on your doorbell mechanism when activated. Note: Files must be
in mp3 format.
• Once you have located those files, simply "COPY" the file and
"PASTE" it into the folder that contains the pre-installed doorbell
files.
• Confirm that the transfered files are complete.
4. Remove USB cable and proceed to one of the following sections.
B
C
FIGURE 1
INSTALLATION & OPERATING INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
NEW WIRED CHIME INSTALLATION
WARNING
•
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
•
Use this unit only in the manner intended by the manufacturer. If you have
questions, contact the manufacturer at the address or telephone number
listed in the warranty.
•
Before servicing or cleaning unit, switch power off at service panel and
lock the service disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting means cannot
be locked, securely fasten a prominent warning device, such as a tag,
to the service panel.
•
Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards, including
fire-rated construction codes and standards.
•
When cutting or drilling into wall or ceiling, do not damage electrical wiring
and other hidden utilities.
•
Use NuTone 16 volt transformer with a minimum rating of 10 VA (purchase
®
separately).
•
When stapling wires to studs or joists, do not allow staples to cut through
wire insulation.
1. Mount the transformer to a junction box (attic location is not
recommended) or circuit breaker box.
2. Connect house power leads to transformer leads: black to black,
white to white, ground to green. (Figure 2)
WIRES
TO
CHIME
3. Route 2-conductor 18-22 gauge wire from the transformer screw termi-
nals and from the pushbutton terminals to the chime location. (Figure 3)
SCREWLESS
WIRING CONNECTOR
ON CHIME BASE
4. Label all wires at chime location in the following manner:
"F" – Front Pushbutton Wire
"T" – Transformer Wire
"R" – Rear Pushbutton Wire (if installed)
1
SUPPLY
WIRE
WIRING DIAGRAM
REAR DOOR PUSHBUTTON
TRANSFORMER
FRONT DOOR
PUSHBUTTON WITH
DIODE INSTALLED
FIGURE 2
120 VAC
WIRING
FIGURE 3