NuTone LA-228WH Instrucciones De Instalación Y Funcionamiento

Wireless Chimes
MODELS: LA-228WH
or LA-245MR
•
For use with the LA-206TWH
MOUNTING THE PUSHBUTTON TRANSMITTER
TO OPEN COVER
"PUSH"
SCREW HOLE FOR WALL
MOUNTING
SCREW HOLE FOR WALL
MOUNTING
SOUND SELECTION
WESTMINSTER
TWO NOTE
ONE NOTE
Congratulations on your purchase of a NuTone wireless chime. The chime operates
by a radio frequency signal transmitted by the pushbutton and received by the chime.
The pushbutton/transmitter is mounted at the door. The receiver may be located
anywhere in your home within 100 feet (30 meters) of the pushbutton. The
pushbutton/transmitter can be programmed to sound one of three chime sounds.
This feature allows up to three pushbuttons to generate three different chime sounds.
Refer to Figures 1 and 2.
1. Locate the pushbutton next to or near
the door.
Do not mount the pushbutton
on a metal surface.
2. Remove the pushbutton cover by
inserting the tip of a screwdriver in
the slot at the bottom of the pushbutton
FIGURE 1
and then gently rock the pushbutton
cover apart from the pushbutton base.
3. Choose a level place to locate the
pushbutton base.
4. Position the pushbutton base,
and mark the mounting surface with
a pencil through the two holes in
the pushbutton.
5. Drill two
the previously marked area.
6. Insert the plastic anchors into
3
the / " diameter holes.
1 6
7. Place pushbutton over anchors,
and fasten with two screws provided.
Do not replace cover at this time.
P U S H B U T TON SOUND CODING
Refer to Figure 3.
1. The pushbutton can be coded to sound
one of three chime sounds.
2. Select the desired sound as illustrated
in Figure 3.
FIGURE 2
LED
CODE SETTING
+ –
INSTALLATION & OPERATING INSTRUCTIONS
3
/ " diameter holes at
1 6
SECURITY
1
2
3
4
5
6
12V "A23"
BATTERY
FIGURE 3
READ & SAVE THESE INSTRUCTIONS!
3. Position the plastic jumper straps
in the proper location for desired
chime sound.
P U S H B U T TON SECURITY
C O D I N G
Refer to Figure 3.
It is not necessary to change the
security code of the pushbutton unless
you experience interference from other
wireless devices.
1. To change the security code, remove
any combination of the six plastic
jumper straps.
2. NOTE: Both the pushbutton and
receiver codes must match.
B AT T E RY INSTA L L AT I O N
Refer to Figure 3.
1. Position the A23 12 volt battery
as illustrated. Be sure to observe
polarity (+/–). For replacement
battery, use EverReady
D u r a c e l l MN21B (or equivalent).
®
I N S TALLING PUSHBUTTO N
C O V E R
Refer to Figure 4.
1. Position the pushbutton cover over
the pushbutton base. The red light
must be lined up over the hole in the
pushbutton cover. Firmly press cover
over base.
A23BP or
®
FIGURE 4