Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NON-DUCTED
RECIRCULATION FILTER
INSTALLATION
1. Purchase a non-ducted recirculation filter
(B03300488) from your dealer.
2. Install the filter by pressing the 2 tabs on
the filter down into the special housing
and rotating upward.
MAINTENANCE
Proper maintenance of the Range Hood will
assure proper performance of the unit.
Grease Filters
The grease filters must be cleaned
approximately once every 30 hours of
operation (when the central segment on the
display goes on or starts blinking).
Use a warm detergent solution. Grease filters
are dishwasher safe.
Remove filter by pushing filter towards the
back of hood and rotating filter downward.
Non-ducted Recirculation Filter
The non-ducted recirculation filter should be
changed whenever the central segment of
the display starts blinking (i.e. every 120
hours of operation). To remove the filter press
inward on the clamp and rotate the filter
downward until the 2 tabs can be removed
from the housing.
Hood Cleaning
Stainless steel is one of the easiest materials
to keep clean. Occasional care will help preserve its fine appearance.
Cleaning tips:
Hot water with soap or detergent is all that is usually needed.
●
Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to
●
avoid water marks.
For discolorations or deposits that persist, use a non-scratching household cleanser
●
or stainless steel polishing powder with a little water and a soft cloth.
For stubborn cases, use a plastic scouring pad or soft bristle brush together with
●
cleaser and water. Rub lightly in direction of polishing lines or "grain" of the
stainless finish. Avoid using too much pressure which may mar the surface.
DO NOT allow deposits to remain for long periods of time.
●
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere
●
to the surface causing rust.
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to
●
remain in contact with stainless steel for extended periods. Many of these com-
pounds contain chemicals which may be harmful. Rinse with water after expo-
sure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
GREASE
FILTERS
CLAMP
- 11 -
NON-DUCTED
RECIRCULATION
FILTER
TABS
NON-DUCTED
RECIRCULATION
FILTER
Tabla de contenido
