geberit ECO 301 Manual De Operación página 29

3
Place the pressing jaw onto the pressfitting, see the operating instructions for the
pressing jaws.
4
Press and hold the start button for about 2 seconds until the automatic pressing
function activates (see cover page in the back, figure D).
5
Wait until the roller drive moves back automatically.
6
Release the pressing jaw from the pressfitting.
Repeat the pressing operation
The pressing operation must be repeated if it was interrupted. Depending on the state of the
initial pressing, there may be considerable idle stroke before the pressing tool engages.
CAUTION
Insufficiently strong connection from incorrect positioning of the pressing collar
Make sure that the catch of the pressing collar is located in the same position as
before the pressing sequence was interrupted
1
Press the stop button.
2
Press the start button. Roller drive moves to its starting position.
3
Press the start button and hold it for about 2 seconds until the automatic pressing
function activates.
B266-004 © 05-2015
964.869.00.0 (03)
EN
29