Device Elements; Accessories; Start Up; Operation - Kärcher HV 1/1 Bp As Manual De Instrucciones

Device elements

Illustration on the inside of the front
cover
1 Eco button (energy saver mode)
2 Power switch
3 Unlocking mechanism for dirt container
4 Dirt receptacle
5 Battery pack
6 Suction support
7 Suction hose port release mechanism
8 Battery pack release mechanism
9 Charge level display / Test button, bat-
tery pack
Battery pack control elements
Lithium-Ion Power
1 2

Accessories

Some of the illustrated or described acces-
sories are not included in the standard
scope of delivery and depend on the equip-
ping variant.
Equipment variants:
Charger
Battery pack
Suction pipe
Floor nozzle
Upholstery nozzle
Dusting brush
Car interior suction noz-
zle
Flexible suction hose
Crevice nozzle
Carrying belt
1 Charge level display
2 Test button (power)
Fs As
X X
X X
2x
X
X
X
X
X
X X
 Select the desired accessory and plug it
onto the suction pipe or directly into the
device.
ATTENTION
Danger of tipping over! Do not set the de-
vice down when using the flexible suction
hose. Hold the device in one hand during
cleaning.
 Push the battery pack into the mounting
in the device until it audibly latches into
place.
Switching the device on/off
 Press the power switch halfway, the de-
vice starts up.
 Release the power switch, device
stops.
 Press the power switch until it latches
into place: Continuous operation.
 Press the power switch - latch disen-
gages and the device stops.
Eco button (energy-saving mode)
Eco mode (energy saver mode): The appli-
ance works with reduced suction perfor-
Cs
mance. The battery life will extend.
X
 To switch on eco mode: Press the eco
X
button.
 To switch off eco mode: Press the eco
button again.
The most recently selected mode re-
mains stored when the device is
X
switched off and is reactivated when the
device is switched on again.
Battery pack charge level display
X
Note
X
Please read and adhere to the battery pack
X
operating instructions.
The battery pack is equipped with a charge
level display.
The current charge state is displayed when
the battery pack is in the vacuum cleaner or
charger.
– 3
EN

Start up

Operation

13