Tabla de contenido
Idiomas disponibles
Idiomas disponibles
After cleaning:
Reinsert the mains plug or
switch on the fuse. Switch on
the appliance with the POWER
button.
Have your supplier inform you
about special cleaning and care
information for appliance
surfaces.
Wipe appliance surfaces with
a damp cloth. Then immediately
wipe dry.
Odors
If the appliance is emitting
unpleasant odors:
Switch off the appliance with
the POWER button!
Pull out the mains plug or
switch off the fuse.
Take all food out of the
appliance.
Clean the interior.
See section on „Cleaning the
appliance".
Change the odor filter.
See section on „Changing the
odor filter".
Thoroughly clean all packing
containers used in the
appliance.
Pack strong-smelling food in
airtight containers to prevent the
build up of odors.
Switch on the appliance again
with the POWER button.
Stack food in the appliance.
After 24 hours check whether
the odors have been eliminated.
Warning
messages
via the display
If several warning messages are
displayed simultaneously, deal with
each message individually.
While a warning message is
displayed, buttons cannot be
pressed.
Door alarm
Cause
– An appliance door has not been
closed properly or has been open
too long.
Remedial action
Close the door. The display goes
out.
Sensor fault
Cause
– A technical defect is possible.
Remedial action
Conduct an appliance self-test.
Low voltage
The display light has gone out.
Cause
– The mains voltage has dropped
below the permitted limit value.
Remedial action
Buttons cannot be pressed. When
the mains voltage reaches the
stipulated value again, the warning
message goes out. If the warning
message is prolonged, inform your
power supply company.
Appliance
self-test
Before you call customer service,
conduct an appliance self-test.
Switch off the appliance and
wait 5 minutes. Keep the door
closed.
Switch on the appliance.
Simultaneously hold down the
SETUP and ALARM OFF
buttons for 5 seconds.
The self-test starts. Different
messages are display in succession.
15
Capítulos
Tabla de contenido
