Bosch GLL3-330C Instrucciones De Funcionamiento Y Seguridad página 12

• Do not switch the laser tool back on
after it has been switched off by the
protective circuit. The battery pack can be
damaged.
To insert the charged battery pack 15, align
battery pack and slide it into the battery port
until it locks into position. Don't force.
To remove the battery pack 15, press the
battery release tab 13 and pull the battery
pack out of the battery port 10. Do not use
force to do this.
Operation with LR 6 (AA) Batteries
A l k a l i - m a n g a n e s e
recommended for the laser tool.
The batteries are inserted into the battery
adapter.
• The non-rechargeable battery adapter
is intended only for use in designated
Bosch laser tools and must not be used
with power tools.
To insert the batteries, slide the cover 11 of
the battery adapter into the battery port 10.
Place the batteries in the cover as shown in
the illustration on the sealing cap 14. Slide
the sealing cap over the cover until you feel it
click into place.
To remove the batteries 12 press the battery
release tab 13 of the sealing cap 14 and
pull off the sealing cap. Make sure that the
Button Cell
Activation/Replacement
To enable the communication of this laser
leveling tool in the off state to a mobile
terminal/device, the laser leveling tool is
equipped with a button cell.
To activate the included button cell:
1. Remove the button cell holder 22 from the
button cell port 23.
2. Remove the protective film from the button
cell 21.
3. Insert the button cell 21 (CR 2032) into the
button cell holder 22. Make sure that the
positive pole is pointing upwards.
4. Insert the button cell holder 22 into the
button cell port 23.
5. Ensure button cell holder 22 is secured
into button cell port 23.
2610050360 01-18 GLL3-330CCG.indd 12
batteries do not fall out. To do so, hold the
laser tool with the battery port 10 facing
upward. Remove the batteries.
To remove the inside cover 11 from the
battery port 10, reach into the cover and
pull it out of the laser tool by applying light
pressure to the side wall.
Always replace all batteries at the same time.
Only use batteries from one brand and with
the identical capacity.
• Remove the batteries from the laser tool
b a t t e r i e s a r e
Battery Status Indicator
The battery status indicator 2 shows the
charge condition of the battery pack or
batteries:
When replacing a button cell, follow step 1
and steps 3-5.
When the button cell runs out of energy, the
app displays a warning.
batteries away from children. This product
contains a lithium button/coin cell battery. If a
new or used lithium button/coin cell battery is
swallowed or enters the body, it can cause
severe internal burns and can lead to death in
as little as 2 hours. Always completely secure
the battery compartment. If the battery
compartment does not close securely, stop
using the product, remove the batteries, and
keep it away from children. If you think batteries
might have been swallowed or placed inside
any part of the body, seek immediate medical
attention.
-12-
when not using it for extended periods.
When storing for extended periods, the
batteries can corrode and self-discharge.
LED
Continuous lighting, green
Continuous lighting, yellow
Continuous lighting, red
No light
If the battery pack or the batteries are running low, the
laser lines will gradually become dimmer.
Immediately replace a fault battery pack or empty bat-
teries.
Chemical Burn Hazard.
Keep lithium button/coin
Charge Condition
100–75 %
75–35 %
35–10 %
– Battery pack defective
– Batteries empty
1/12/18 3:12 PM