Tabla de contenido
Idiomas disponibles
Idiomas disponibles
17.4 Lubricating the Gearbox
17.5 Setting the Idle Speed
centre and do not use the machine again until it has been properly adjusted or repaired.
17.6 Cleaning the Spark Plug
18
STORAGE
Observe all safety precautions for the safe storage and handling of petrol.
Improper storage can damage and destroy important components. Only store packed
or unpacked parts under the intended ambient conditions!
In the case of a longer interruption of operation (> 30 days) or during decommissioning, observe
the following points:
- Clean the machine thoroughly and keep the blades frost-free and out of the reach of
children.
- Before storing the machine, empty all fuel into a container approved for petrol. Then let
the engine run until it stops.
- Store the machine in a dry environment protected from frost and other weather
conditions.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-BHS605
The gearbox is lubricated at the time of delivery of the
machine, but must be relubricated at regular intervals (see
maintenance schedule).
Lubrication is carried out via the lubrication nipple (1) on the
side of the gearbox housing - see illustration on the left. Use a
multi-purpose grease of class NLGI 2 or an equivalent
product.
First check that the air filter is clean, as it may affect the
result.
If the idle speed is correct, the cutter blade should not
move when the machine is idling.
Use the idle screw (X) to adjust. Turn in direction y:
Increase speed, direction z: Decrease speed.
Procedure:
If the idle speed cannot be adjusted so that the cutter
blade no longer moves, contact your dealer/service
Remove the spark plug and clean it of soot and other impurities with a
brush. Then check the distance between the contacts. It should be 0.6 to
0.7 mm (see illustration on the left), which is approximately the thickness
of a credit card. Then reinstall the spark plug. For optimum performance,
the spark plug should be replaced once a year. You will find the article
number in the spare parts list.
DANGER
NOTICE
Close the idle adjustment screw while the engine
is running (turn counterclockwise) until the cutting
tool begins to rotate.
STORAGE
24
Tabla de contenido
