Connect Ac Adapter; Synchronising And Placing Sensors - Oregon Scientific RAR502S Manual Del Usuario

COnneCT AC ADAPTeR

Connect the supplied power adapter to the power jack,
then plug into a standard AC outlet.
nOTe
• The batteries are only for back-up use. Always
connect the unit to the power grid source via AC/DC
adapter.
•
Make sure the adapter is not obstructed and is
easily accessible to the unit.
• The base station and adapter should not be exposed
to wet conditions. No objects filled with liquid, such
as vases, should be placed on the base station and
adapter.
• To completely disconnect from power, unplug adapter
from the mains.

SYnCHROnISInG AnD PLACInG SenSORS

The main unit will automatically search for new
sensor reset within the last 30 minutes. If unit failed to
synchronise with remote sensor, reset both the main
unit and sensor or try selecting a different channel (and
press ReSeT).
The remote sensor reception icons will show the following
status:
ICOnS
and "--.-"
Place the remote sensor within 30 m (98 ft) from the
main unit.
TIP
•
When placing sensors, remember the intended
location for each sensor. Refer to channel switch
position (1, 2, 3) and match with channel icon
displayed directly above name tag.
•
The transmission range may vary depending on
many factors. You may need to experiment with
various locations to get the best results.
For best results:
•
Place the sensor out of direct sunlight and moisture.
•
Position the sensor so that it faces the main unit,
minimizing obstructions such as doors, walls and
furniture.
•
Place the sensor in a location with a clear view to
the sky, away from metallic / electronic objects.
5
MeAnInG
Main unit is searching
for sensor(s)
A sensor has been
found and logged on
No sensor found