ROBBE Power Peak Twin EQ-BID Manual De Uso página 199

14. hLášENí ChyB
Aby byl zajištěn bezpečný průběh nabíjecího anebo vybíjecího pochodu. je nabíječ Power
Peak ® Twin EQ-BID vybaven bezpečnostními zařízeními. Pokud dojde k chybě, objeví se
odpovídající hlášení v displeji a piezzo-bzučák vyšle pronikavý výstražný tón. Následující
hlášení chyb lze po odstranění příčiny pomoci tlačítka 'ESC' kvitovat.
[ INPUT VOLTAGE ]
*The input voltage is 10.86 V
*Please check the Input vol-
tage!
[ NO BATTERY ]
*No Battery
is connected to the output.
[ REVERSE POLARITY
*The battery is connected
with reverse polarity to the
output!
[ BREAK ]
*The battery connection
is disconnected.
*Please connect the battery
and connect
[ DATA COMMUNICATION
*Contact the
robbe Service department.
Návod k obsluze
Power Peak ® Twin EQ-BID
[ SHORT CIRCUIT
The output
has a short circuit
*Please check the Output!
[ VOLTAGE TOO LOW
*Output voltage is
lower than the
selected cell count or Voltage
] [ VOLTAGE TOO HIGH
*Output voltage is
higher than the
selected cell count or Voltage
[ TEMPERATURE SENSOR
*The Temperature sensor
is reverse polarity or defective.
[ BID CHECK SUM
]
BID is defective,
press any button to initialise.
[ BATTERY TEMP. TOO LOW
]
*The battery temperature
is for safe operation too low!
[ BATTERY TEMP. TOO HIGH
]
]
*The battery temperature
is for safe operation too high!
] [
]
*The internal temperature
is too high!
[ WRITE BID DATA
]
*The Data will
not be stored
in the BID system.
*If this message
is displayed continuously,
replace the
BID System.
]
[EQUALIZER VOLTAGE TOO
HIGH]
Equalizer voltage
is too high.
29
INTERNAL TEMPERATURE
]
]