Package Contents; Electrical Safety - DeWalt DCL043 Traducido De Las Instrucciones Originales

ENGLISH
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care
for the environment.
Charge D WALT battery packs only with
E
designated D WALT chargers. Charging
E
battery packs other than the designated
D WALT batteries with a D
E
charger may make them burst or lead to
other dangerous situations.
Do not incinerate the battery pack.

Package Contents

The package contains:
1 Spotlight
1 Instruction manual
• Check for damage to the spotlight, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 5)
WARNING: Never modify the spotlight
or any part of it. Damage or personal
injury could result.
a. Switch
b. Loop hook
c. Pivoting head
d. Battery pack
e. Battery release button
26
f. Belt hook screw
g. Belt hook
h. Fuel gauge button (Fig. 5)
INTENDED USE
The DCL043 spotlight is designed to use as a light
source.
The DCL043 spotlight is a professional appliance.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The spotlight has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
WALT
E
Also make sure that the voltage of your charger
corresponds to that of your mains.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
Use an approved extension cable suitable for the
power input of your charger (see Technical Data).
Your D WALT charger is double insulated
E
in accordance with EN 60335; therefore
no earth wire is required.
WARNING: No connection is to be
made to the earth terminal.