Idiomas disponibles
Idiomas disponibles
TECHNICAL
TRAINING
POINTER
29. Locate Tub Seal and Grease. Apply grease to both
cavities inside Tub Seal lip. See Figure 17.
30. Apply the Pliobond Adhesive in a continuous bead
around bottom of Tub Seal to enter tub first. Verify
grease is inside the seal. See Figure 18.
31. Push Tub Seal into place using the Seal Press Tool
and hammer until it bottoms out. Add a bead of
Pliobond Adhesive to top edge of seal and tub (spread
out with finger). See Figure 19.
Page 5
® Registered trademark of Whirlpool, U.S.A., KitchenAid, U.S.A., Jenn‐Air, U.S.A., or Maytag Properties, LLC or its related companies.
For Immediate Attention of Your Service Department
Technical Training Pointer #: W10470122A
Release Date: November, 2012
Remove and Replace W10470122 Dated 11/11
Figure 17
Figure 18
®MAGIC CHEF is a registered trademark of CNA International, used under license. © 2012 All rights reserved.
32. Reinstall basket.
33. Reinstall tub ring, hose, and hose clamp.
34. Close top.
Plug into a grounded (earthed) outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
35. Plug in washer or reconnect power.
36. Verify repair by performing Diagnostic Test.
Laundry Products
Figure 19
WARNING
Electrical Shock Hazard
