Idiomas disponibles
Idiomas disponibles
TECHNICAL
TRAINING
POINTER
10. Remove Shaft Nut. See Figure 6.
11. Remove drive shaft and seal (with hammer). See
Figure 7.
HAMMER
12. Tip washer forward off the hoses and remove drive
shaft and seal from tub. See Figure 8.
REMOVE SHAFT
13. Drive Bottom Bearing, Bottom Bearing Washer, and
Spacer Tube out using Removal Rod and hammer. See
Figure 9.
Page 3
® Registered trademark of Whirlpool, U.S.A., KitchenAid, U.S.A., Jenn‐Air, U.S.A., or Maytag Properties, LLC or its related companies.
For Immediate Attention of Your Service Department
Technical Training Pointer #: W10470122A
Release Date: November, 2012
Remove and Replace W10470122 Dated 11/11
Figure 6
Figure 7
Figure 8
®MAGIC CHEF is a registered trademark of CNA International, used under license. © 2012 All rights reserved.
REMOVAL ROD
14. Tip washer back on hoses and drive Top Bearing out
using Removal Rod and hammer. Discard all parts. See
Figure 10.
15. Tip washer forward off of hoses.
16. Clean bearing and seal areas with a rag. Check the
weep hole (make sure it is not plugged). See Figure 11.
Laundry Products
Figure 9
REMOVAL ROD
Figure 10
Figure 11
