Idiomas disponibles
Idiomas disponibles
TECHNICAL
TRAINING
POINTER
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Tape lid shut before opening top. Open top. See
Figure 1.
3. Remove hose clamp and hose from tub ring.
4. Remove tub ring.
5. Remove cap from either wash plate or agitator. See
Figure 2.
Page 2
® Registered trademark of Whirlpool, U.S.A., KitchenAid, U.S.A., Jenn‐Air, U.S.A., or Maytag Properties, LLC or its related companies.
For Immediate Attention of Your Service Department
Technical Training Pointer #: W10470122A
Release Date: November, 2012
Remove and Replace W10470122 Dated 11/11
Bearing Replacement Kit Procedure
Figure 1
Figure 2
®MAGIC CHEF is a registered trademark of CNA International, used under license. © 2012 All rights reserved.
6. Remove 7/16" bolt. Lift and remove basket assembly
with wash plate/agitator. See Figure 3.
7. Slide washer out and tip back on hoses.
8. Using a ¼" Hex Driver, remove rotor bolt and rotor.
See Figure 4
9. Remove four (4) stator bolts (5/16" or 3/8"). Unclip
wire harness and remove stator and shield. Set stator
on a clean rag on the floor. See Figure 5.
STATOR
BOLTS
Laundry Products
Figure 3
Figure 4
Figure 5
