General Description - GYS NEOSTART 420 Manual De Instrucciones

GENERAL DESCRIPTION

Congratulations for the selection of this product which has been designed with great care. To get the
best of it, please read carefully the following recommendations. Keep it for future reading if
necessary.
The NEOSTART are designed to:
charge liquid electrolyte lead-acid batteries :
- from 20Ah to 1000Ah in 12V or 24V for the NEOSTART 420
- from 20Ah to 1350Ah in 12V or 24V for the NEOSTART 620
start vehicles with liquid electrolyte lead-acid batteries :
- from 35 to 160Ah in 12V or 24V for the NEOSTART 420
from 45 to 200Ah in 12V or 24V for the NEOSTART 620
-
Assembly of the handle and
wheels
USE IN CHARGING MODE (CHARGE)
CAUTION: these machines are « traditional ». The battery charge will need to be watched and this
charge will only stop when the operator places the power switch on OFF or unplugs the charger from
the mains.
Prior precautions
• Choose a sheltered but ventilated area unless specially fitted.
• Remove the battery caps (if the battery is fitted with) and be sure that the liquid level (electrolyte)
is right. Otherwise, add some distilled water. Carefully clean the lugs and terminals of the battery.
• Check that the capacity (in Amps per hour) and the voltage (in Volts) are compatible with your
charger.
Connecting and unplugging
Do not connect to the mains at the beginning.
Turn the switch of the machine on OFF
Connect the red cable on the NEOSTAT terminal +12V ou 24 V depending on the
voltage of the battery
Connect the clamp (+ red and – black) to the + and – terminals of the battery
making sure you get a good electrical contact and respecting the following order:
- First, connect the terminal which is not linked to the vehicle chassis.
- Then, connect the terminal to the chassis, in a location far from the battery and
from combustible pipes
Connect the charger input to the mains (230V 50Hz).
Place the selector on the position Charge 1 or Charge 2:
Neostart 420: Charge 1: 35 to 120 Ah Charge 2: 120 to 400 Ah
7