Before You Start - Rowenta CRIMPER CF7013F0 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
CF7013 038848 crimper
DESCRIPTION
1.
Crimper
2.
Accessory locking – and
unlocking – ring
3.
Crimping plates with ceramic
coating : tight crimping
4.
Crimping plates with ceramic
coating : large crimping

BEFORE YOU START

Inserting the crimping
plates
Choose the plate (large crimping
– fig.1
or close crimping
fig.2
) according to the effect
you want.
Press the lever to open the tong.
Insert the first plate by sliding it on
the groove until your hear a "CLICK "
- fig. 3.
Repeat the procedure with the
second plate.
Plugging in your hair
styler
Place the appliance in a stable
position on its rest on a flat surface.
Plug it in and set the On/Off
switch to On (position 1).
The 'Power on' light will come on
- fig. 4
and the accessory will
begin to heat up.
Wait a few minutes to allow your
hair styler to reach its working
temperature (10 min).
11/04/06
8:45
5.
"Power on" light
6.
On/Off switch (1-0)
7.
Handle
8.
Swivel power cord
To remove the plates
When removing plates, always
hold
them
part – the metal parts will be very
hot.
Press the lever to open the tong.
Press the unlocking botton on the
first plate
remove it.
Repeat the procedure with the
second plate.
IMPORTANT
The ceramic coating protects
your hair from excessive
heat, thanks to an even
distribution of the heat.
5
Page 5
by
the
plastic
– fig.5
, then slide it to
GB
Tabla de contenido
loading

Tabla de contenido