Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GENERAL FUNCTIONS OVERVIEW
Most of the common functions are explained in the previous chapter "controls and functions" In this chapter we
talk about the functions that need a little more explanation.
SOME GENERAL FUNCTIONS:
SLEEP MODE:
The CD player automatically shuts off the transport and laser after about 15 minutes (when in pause or cue
mode). This extends the life of your motor drive and laser. During sleep mode the display shows the word
"SLEEP". To wake up the player, just press the cue or play button, the display turns to normal and is ready
to receive instructions.
RELAY FUNCTION:
First open the 2 faders of the CD inputs on your mixer. Press the RELAY button to enable the relay function,
the relay LED turns on. Put a disc in both players and start playback on one of the units. Alternately at rack
will be played from both units until the relay function is disengaged. You can always put a new CD in the
player that is waiting in pause. In this way you can create an endless program, perfect for use in pubs etc
PITCH BENDING:
This function is used to synchronize the beats of two tracks. This can be done in two ways:
(1) PITCH BEND buttons: The speed increases or decreases respectively as long as the PITCH BEND+ or
PITCH BEND- buttons are pressed.
(2) JOG WHEEL: During play mode the JOG WHEEL will temporarily bend the pitch of the music by turning
the JOG WHEEL clockwise to speed up or counterclockwise to slowdown. The rotation speed the JOG
WHEEL determines the percent of pitch bend.
PLAYING/RECORDING CD-R and CD-RW
Apart from normal audio CD's the unit can play both CD-R (CD recordable) and CD-RW (CD rewriteable).
Please note that you should always use the "disc at once" and "track at once" disc writing options! Although
the unit is capable of reading CD-R and CD-RW recorded at higher speeds, we suggest not using recording
speeds more than x12 to increase readability. Always buy good quality brands for CD-R and CD-RW! If the
disc is multi session, it will only play the first session.
ABOUT LOOPS
CREATE A LOOP
While a track is playing, press IN button to program the starting point of the loop. Now press the OUT button to
program the endpoint of the loop. The seamless loop start splaying at once.(With some practice you will be
able to create perfect loops!) While the loop is playing, you can press the OUT button again to exit the loop and
continue the rest of the track.
RESTART A LOOP
This can be done in 3 ways
(1) When a loop is programmed and you left it by pressing the OUT button, just press RELOOP to restart the
loop.
(2) When a loop is programmed and you left it by pressing the OUT button, just press OUT again to restart
the loop. The point where you pressed OUT is now programmed as the new endpoint of the loop.
(3) When the loop is still playing, press the RELOOP button to restart the loop immediately. You can repeat
this several times to create a "Stutter" effect.
Frame search
This is done by first pausing then using the jog wheel to set the starting point. (When you use the jog wheel
the monitor function allows you to hear what is playing.) Once you reach your desired starting point, you can
set a cue (starting) point by pressing PLAY/PAUSE button.
7
Tabla de contenido
