Andis LCL-2 Instrucciones De Uso Y Cuidado página 6

20. WARNING: Cutting blades may become hot
after prolonged use. Oil blades frequently.
21. Cleaning and user maintenance shall not be
made by children without supervision.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
UNIVERSAL AC/DC POWER ADAPTER
1. Remove the wall adapter and clipper from the carton.
2. The clipper comes standard with a universal AC voltage wall adapter and
interchangeable plugs (Figures A-E).
3. To attach the desired plug to the wall adapter, align the slots on the plug to the ribs
on the wall adapter and slide into place. The plug will "click" into place when
properly attached. To remove, locate the button marked "push" on the wall
adapter. Press the button and slide the plug from the wall adapter. The plugs for
the various countries all attach and remove using the same method (Figure F).
4. Plug the adapter cord directly into the receptacle on the bottom of the clipper
(Figure G) and then insert the transformer into an AC outlet.
CHARGING CLIPPER
The 4.5V 1.2A AC adapter is only intended for use with Andis Model LCL/LCL-2
lithium-ion clipper. Remove the clipper and AC adapter from the carton. Plug the AC
adapter into a 100-120V, 50-60 cycle AC outlet, or as noted on the unit. Plug the
adapter cord directly into the receptacle on the bottom of the clipper (Figure G). The
clipper ON/OFF switch must be in the OFF position for the battery to charge. The
green light on the clipper will turn ON when the clipper is charging. When clipper is
fully charged, the green light will turn OFF.
The clipper has not been charged at the factory. Please charge the clipper for 3-5
hours before FIRST use for maximum performance. When battery is fully charged,
clipper can be used for up to 2 hours of continuous run time. After first use,
clipper will fully charge in a minimum of 90 minutes.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you know
is working).
2. Make sure ON/OFF switch on the clipper is OFF.
3. Check to make sure adapter cord is plugged firmly into clipper.
4. If failure to charge still exists, return clipper to Andis or an Andis authorized service
station for examination and repair or replacement.
6