Sunbeam SD113232 Instrucciones De Montaje página 5

D
Long End
42
DP
KR
DP KR
DP
D1
48
DQ
Front
E
49
DP
KR
DP
KR
KR
KR
DP
DP
Back
48
D2
DQ
DQ
Back
49
E1
Soup can
included
D
Remove the following parts from the carton:
One BOTTOM CASTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(42)
Two GREASE DRIP PANS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(48)
Set the BOTTOM CASTING (42) upside down. Install the long ends of six spacers (DP)
into the six tabs on the Bottom Casting secure inside with six hex nuts (KR). Note: The
Bottom casting front has only two tabs, the back has four tabs.
Remove the six knurl nuts (DQ) from the six spacers (DP). Do not loosen the spacers from
the hex nuts (KR) inside the bottom casting. Align the front hole in one of the GREASE
DRIP PANS (48) with spacer on the front of the bottom casting and insert the spacer into
the Grease pan. (Note: The front hole on the Grease pan is larger so it can slide over the
spacer.) See detail D1. Gently rotate pan and align the rear holes in the drip pan with the
spacers in the bottom casting. Then insert spacers into the pan and secure with three Knurl
nuts (DQ). See detail D2.
Repeat assembly for the other Grease Drip Pan.
E
Remove the following parts from the carton:
Two GREASE PAN WIRES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(49)
Thread the GREASE PAN WIRES (49) into the Grease drip pans.
Note: Soup can not included. See detail E1.
not
Hardware shown actual size
(6) Qty.
(6) Qty
(6) Qty.
(Pg. 5) 1141-1986