Steam Cleaning; Technical Data; Troubleshooting - Black+Decker FSM1616 Manual De Instrucciones

(Original instructions)
ENGLISH
The easiest way to use the appliance is to tilt the handle
to a 45º angle and clean slowly, covering a small area at a
can pre-treat with a mild detergent and some water before

Steam Cleaning

Lightly press the steam mop down onto the cleaning pad
Note!
The steam mop will now glide easily over the surface to be
the handle (4) to the upright position, making sure that it
Caution! It is important to monitor the water level in the water
clean stand the mop upright making sure that the handle is
Caution!
with the handle (4) supported in the upright position when
stationary and make sure the steam mop is turned off when
After use (Fig. F)
remove the cleaning pad (6) and wash it ready for next
Clip the supply cable around the cable tidy hooks (7 and
8)
6
There is a hanging bracket (10a) built into the hand grip
(9) which allows your steam mop to be hung from a
hook is capable of supporting the weight of the steam mop

Technical Data

FM1616
(Type 1)
Voltage V 230
ac
Power W 1600
Tank
ml 350
Capacity
Weight kg 2.3

Troubleshooting

If your appliance seems not to operate properly, follow the
Problem Step
The steam mop is not
turning on
The steam mop is not
producing steam
The steam mop is
producing too
much steam during
use.
The steam mop is
producing too
little steam during
use.
The steam mop stops
producing steam
during use
The steam mop stops
producing too little
steam during use
BDS1616R
(Type 1)
230
1600
350
2.3
Possible solution
Check the unit is
plugged in at the wall
Check the unit is
switched on using the
Check the fuse in the
Check the water tank
(3) is full and correctly
NOTE:
or after running dry it
can take up to 45
seconds for steam to
Check the steam
generation button is in
The steam mop has 3
thumbwheel control dial
(10) to reduce the
amount of steam being
The steam mop has 3
thumbwheel control dial
(10) to increase the
amount of steam being
Check step 1, then 2,
Check step 4, then 2,
then 3