Standard Accessories; Prior To Operation - Hitachi H 65SD2 Instrucciones De Manejo

DEMOLITION HAMMER SAFETY WARNINGS
1. Wear ear protectors.
Exposure to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Do not touch the bit during or immediately after operation.
The bit becomes very hot during operation and could
cause serious burns.
SPECIFICATIONS
Voltage (by areas)*
Power Input
Full-load Impact Rate
Weight (without cord, side handle)
* Be sure to check the nameplate on this Demolition Hammer as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case .............................................................................1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
○ Asphalt Cutting
(1) Cutter
○ Groove Digging and Edging
(1) Cold Chisel
○ Crushing
(1) Bull Point
○ Scooping Work
(1) Scoop
Overall Length: 410, 520 mm
Width: 75 mm
Overall Length: 410, 520 mm
Overall Length: 410 mm
Overall Length: 546 mm
4. Before starting to break, chip or drill into a wall, fl oor or
ceiling, thoroughly confi rm that such items as electric
cables or conduits are not buried inside.
5. Properly set the bit holder
6. At the start of work, confi rm screw tightening.
7. When working at a highly elevated location, pay attention
to articles and persons below.
8. Wear protective shoes to protect your feet.
(110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V)
1340 W*
1400/min
18.5 kg
○ Grease
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without notice.
APPLICATIONS
This Demolition Hammer should be applied to demolishing
concrete, chiseling off concrete, grooving, bar cutting
installation of piping and wiring, sanitary facility installation,
machinery installation, water supply and drainage work,
interior jobs, harbor facilities and other civil engineering
works.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate of this Demolition Hammer.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, this Demolition Hammer
will start operating immediately, which could cause a
serious accident.
3. Extension cord
When the work area is remote from the power source,
use an extension cord of suffi cient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
4. Mounting an accessory, such as a bull point, a
cutter, etc.
CAUTION
Be sure to switch OFF and disconnect the attachment
plug from the receptacle to avoid a serious accident.
NOTE
For accessories such as a bull point and a cutter, use
only Hitachi genuine parts.
English
5