Firmware Settings - Swan Analytical Instruments Cleaning Module-II Instrucciones De Instalación

Cleaning Module-II

Firmware Settings

4.
sponding AMI Instrument. When the cleaning module is connected,
the menu item Cleaning will appear in the menu list Maintenance.
A-96.250.599 / 020620
Firmware Settings
The Cleaning Module-II is controlled by the transmitter of the corre-
The following modes can be chosen:
Maintenance
Calibration
Service
Simulation
Set Time 30.09.14 11:35:44
Cleaning
Cleaning
Mode
Parameters
Interval
Fill Channel 11
daily
Fill Channel 12
weekly
off
Installation
Sensors
Signal outputs
Relay contacts
Miscellaneous
Interface
Sensors
Cleaning
Dimension
1 Solution
Interpolation
2 Solutions
Ref. Verification
Standards
Cleaning
Further information on firmware settings can be found in chapter 9
of the corresponding manual.
3.5
3.5.1
5.1
5.1.6
17