Installing The Tv On The Wall - Sony SU-WL450 Información De Instalación

5
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV is
installed.
Note
 Subcontract the cable routing in the wall to a
licensed contractor.
 Bundle the connecting cables to prevent stepping
on them before wall mounting.
6
Detach the Table-Top Stand from
the TV.
Note
 Be careful when lifting the TV as the Table-Top
Stand is detached, the Table-Top Stand may topple
over and cause personal injury.
 Take care when removing the Table-Top Stand from
the TV to prevent it from falling over and damaging
the surface that the TV is sitting on.
 Do not remove the Table-Top Stand for any reason
other than to install corresponding accessories on
the TV.
 Be sure the TV is vertical before turning on. To
avoid uneven picture uniformity do not power on
the TV with the panel facing down.
 When attaching the Table-Top Stand again, be sure
to fasten the screws (previously removed) to the
original holes on the rear of the TV.

Installing the TV on the Wall

XR-83A9xJ only
WARNING
 Be sure that two or more persons (three or more
persons for 189.3 cm (75 inches) and above TV set)
hold the TV when carrying it.
1
Lift the TV.
• For the location of the Pulleys  to hang
on the Base (20)  or Base Adaptor ,
refer to "Base Adapter  fitting location"
on page 18.
• Make sure that the rear of the TV touches
the Base (20)  or Base Adaptor  when
holding the TV.
Note
 Hold the TV securely with both hands and make
sure the Belt  and the bottom of the TV align
with the masking tape.
 Carry the TV with three people and the person who
is in front of the TV leads the others to adjust the
position.
− 11 (GB) −
GB