Preventing Equipment From Falling Over - Pioneer PDK-TS25 Manual De Instrucciones

Preventing Equipment from Falling Over

After installing the stand, be sure to take special care to ensure that the Plasma Display will not fall over.
Because of the plasma display's weight, if it could fall down, this can result in injury.
For safety, be sure to take special care to ensure that the Plasma Display will not fall over.
Stabilizing on TV table or other loca-
tion
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
A TV table with adequate strength, width and depth
should always be used to support the Plasma Display.
Failure to do so could result in falling over.
To stabilize the Plasma Display on a TV table, use screws
that have a nominal diameter of 6 mm (1/4 inch).
Select the appropriate screws after consulting a profes-
sional installer if necessary.
Caution
• A table with adequate strength should always be used
to support the Plasma Display. Failure to do so could
result in personal injury and physical damage.
• When installing the Plasma Display, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as
earthquakes, or of accidents.
• If you do not take these precautions, the Plasma
Display could fall down and cause injury.
• The screws, hooks and other fittings that you use to
secure the Plasma Display to prevent it from
overturning will vary according to the composition and
thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks and other fittings
after first inspecting the surface carefully to determine
its thickness and composition and after consulting a
professional installer if necessary.
Using a wall for stabilization
1
Attaching falling prevention bolts to the
Plasma Display.
2
Using strong cords to stabilize it appropri-
ately and firmly to a wall, pillar, or other
sturdy element.
Perform this work in the same way on the left and
right sides.
The length of the cords used must be long enough to
allow the stand to rotate freely.
Note
Use falling prevention bolts,
ropes and fittings that
are available on the market.
Recommended bolts:
Nominal diameter M8
Min. 20 mm Length 12 mm to 15 mm (1/2 to 5/8 inch)
(13/16 inch)
1
Falling prevention bolts
Fittings
Position of table screws: Without speakers
Unit: mm (inch)
* : 50 inch display model
** : 42 inch display model
2
Cords
120
522 (20-9/16)*
(4-23/32)
460 (18-1/8)**
12 mm to 15 mm
(1/2 to 5/8 inch)
522 (20-9/16)*
460 (18-1/8)**
19
En