Preventing Equipment From Falling Over - Pioneer KURO PDK-TS36B Manual Del Usuario

Preventing Equipment from Falling Over

After installing the stand, be sure to take special care to ensure that the Pioneer television
will not fall over.
• Because of the Pioneer television's weight, if it could fall down, this can result in injury.
• For safety, be sure to take special care to ensure that the Pioneer television will not fall over.
Stabilizing on TV table or other location
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
• A TV table with adequate strength, width and depth should
always be used to support the Pioneer television.
Failure to do so could result in falling over.
• To stabilize the Pioneer
television on a TV table, use
screws that have a nominal
diameter of 6 mm (1/4 inch).
Select the appropriate screws
after consulting a professional
installer if necessary.
• A table with adequate strength should always be used
to support the Pioneer television. Failure to do so could
result in personal injury and physical damage.
• When installing the Pioneer television, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as earthquakes,
or of accidents.
• If you do not take these precautions, the Pioneer
television could fall down and cause injury.
• The screws, hooks and other fittings that you use
to secure the Pioneer television to prevent it from
overturning will vary according to the composition and
thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks and other fittings
after first inspecting the surface carefully to determine
its thickness and composition and after consulting a
professional installer if necessary.
Using a wall for stabilization
1
Attaching falling prevention bolts to the
Pioneer television.
2
Using strong cords to stabilize it
appropriately and firmly to a wall, pillar,
or other sturdy element.
• Perform this work in the same way on the left and
right sides.
• The length of the cords used must be long enough to
allow the stand to rotate freely.
Use falling prevention bolts,
ropes and fittings that are
available on the market.
Recommended bolts:
Nominal diameter M8
Length 1 mm to 15 mm (1/ to 5/8 inch)
❖ Position of table screws: Without speakers
Unit: mm (inch)
9
En