Fiap profiwork Salmofix Sauger Manual De Instrucciones página 3

FIAP profiwork Salmofix Sauger
Reinigung und Wartung
Achtung! Vor Reinigungs- und Wartungsarbeiten immer den Netzstecker ziehen!
Gerät bei Wartungs- und Reparaturarbeiten komplett abschalten und vom Stromnetz trennen. Beim
Umgang mit Risiko-Stäuben mit der gebotenen Sorgfalt umgehen.
Die Maschine und deren Komponenten nicht mit Lösemittel, entzündlichen oder giftigen Flüssigkeiten
reinigen. Zum Reinigen nur ein feuchtes Tuch benutzen. Vorher sicherstellen, dass der Stecker aus
der Steckdose gezogen wurde. Verwenden Sie zur Desinfektion FIAP Desinfektionsmittel speziell für
die Aquakultur. Persönliche Schutzausrüstung benutzen.
Entsorgung
Das Gerät ist gemäß den nationalen gesetzlichen Bestimmungen zu entsorgen.
Fragen Sie Ihren Fachhändler. Bei der Entsorgung der abgeschiedenen Stäube, der Austausch- und
Ersatzteile die örtlichen Vorschriften beachten!
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
5
www.fiap.com
FIAP profiwork Salmofix Sauger
GB
Notes on these instructions
Before first use, please read the operating instructions and familiarize yourself with the device.
Observe the safety instructions for proper and safe use.
Intended Use
FIAP profiwork Salmofix Exhauster, in the following called device has been produced exclusively for
processing of fish and for use at an operating voltage of 220 - 240V.
The device is suitable for use in compliance with the national installation regulations.
Improper use
It can not occur under normal use and dangers of improper handling this device for people with. From
improper use of our liability, as well as the general operating license expires.
CE Declaration
In accordance with the EC Directive EMC Directive (2004/108/EC), conform. The following harmonized
standards were applied:
EN 292–1, EN 292–2, EN 294, EN 563, EN 626–1, EN ISO 11688–1, EN 60034, EN 60204-1, EN
610000-6-2, EN 61000-6-4.
Safety instructions
For safety reasons the potential hazards of this appliance reasons, children under 16 or people who
can not recognize or are not familiar with these instructions, do not use!
Please keep these operating instructions in a safe place! When changing owners pass on the
instructions. All work with this appliance may only be carried out in accordance with these instructions.
With improper handling the combination of water and electricity can lead to serious danger for life.
Operate the unit only if no persons are in the water! Before reaching into the water, always disconnect
the power supply to all devices in the water. Compare the electrical data of the power supply to the
label on the packaging or on the device. Make sure that the unit is secured by a residual current device
with a rated residual current of maximum 30 mA safe. Operate the unit only on a correctly fitted socket.
Keep the power plug and all connection points dry! Lay the connection cable protected so that damage
is excluded. Only use earthed cables, installations, adapters, extension or connection cables that are
approved for outdoor use. Do not carry or pull the unit by the cable! With a defective cable or
enclosure, the unit must not be operated! If the power cord of the appliance is damaged, it must be
replaced by the manufacturer or its service agent in order to avoid a hazard. When the cable is
damaged, the appliance should be discarded. Electrical installations must comply with international
and national installation requirements. Never open the housing of the device or its associated parts,
unless specifically noted in the instructions. Do not make any technical changes on the device. Use
only original spare parts and accessories. Only be carried out by authorized service centers. It must be
ensured that all conductive parts (screws, terminals, etc.) are isolated and can not be touched directly!
For questions or problems, please contact a licensed electrician for your own safety!
management may not become from the Type given by the manufacturer Type H05W-F 2 x 1, 0 mm²
soaked off. By exchange of the mains connection management guarantee the protective kind.
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
1
www.fiap.com