Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1
Flush through the supply pipes.
2
Place the mixer including the sealing
washer in position on the basin / bidet.
3
Slip the slide washer, washer and collar nut
over the threaded base and tighten the
collar nut by hand.
4
Connect the supply pipes to the isolation
valves; cold right - hot left.
5
Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Technical Data
This mixer series-produced with
waterdimmer® (flow limiter).
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
The aerator is not equal to DIN EN 246
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
7 l/min 0,3 MPa
11 l/min 0,3 MPa
max 1 MPa
1,6 MPa
max 80° C
65° C
If the continuous water heater causes any
problems or there is not enough flow of water,
the waterdimmer® (4a/11a) located behind the
aerator must be removed.
Spare parts see page 4
1
handle
2
screw cover cold/ hot
3
spout large model
4
aerator cpl.
5
shut off unit
6
pull rod
7
fixing set
8
connection hose
9
spout small model
10
spout for bidet
11
aerator cpl.
12
sleeve
13
supply pipe
Special accessories
X special tool set 58085000
(order as an extra)
XXX = Colors
000 chrome plated
820 brushed nickel
830 polished nickel
16291XXX
97987000
97990XXX
97991XXX
94009000
98730XXX
13961000
96321000
97992XXX
97364XXX
97360XXX
97993XXX
96638000
5
