The Maxi-Cosi Car Seat - Mutsy NEXO Manual De Instrucciones

Remove the Safe2go car seat
· Press the buttons on both adapters to unlock the Safe2go car seat.
· Lift the Safe2go car seat straight up from the frame.
Remove the Safe2go adapters (x)
· Press the release button (x1) on the adapter. Turn the top of the adapter
outwards (x2) and take the adapter out of the cam from the top. (x3)
Maxi-Cosi car seat
· The Maxi-Cosi car seat adapters are suitable for use with the following
Maxi-Cosi group 0+ car seats: Maxi-Cosi Pebble, Maxi-Cosi Pebble Plus,
Maxi-Cosi Cabriofix, Maxi-Cosi Citi.
· Always observe the instructions in the manual of your Maxi-Cosi car
seat before you start using the car seat.
· Make sure that the frame has fully been unfolded and the brake blocked
during all actions indicated below.
· The car seat can be combined with the pushchair seat.
Place the Maxi-Cosi adapters on the frame (y)
· The adapter marked with 'R' is placed on the right side of the frame, the
adapter e adapter marked 'L' is placed on the left side.
· Remove the bumper bar and the hood.
· There is an opening at the front of the adapter. Put the opening of the
adapter around the cam (y1) on the frame from the outside.
· Turn the top of the adapter inwards (y2) until it clicks. Check that the
adapter has been attached properly by trying to lift it from the frame.
Place the Maxi-Cosi car seat on the adapters
· Orientate the Maxi-Cosi car seat such that it is directed rearwards on the
frame.
· Hold the Maxi-Cosi car seat with the central hinge points of the support
bar directly above the adapters.
· Lower the Maxi-Cosi car seat and press solidly into the adapters until you
hear a click. Check that the Maxi-Cosi car seat has been placed horizon-
tally and has been attached properly by trying to lift it from the frame.
Remove the Maxi-Cosi car seat from the adapters
· Operate the unlocking system of the Maxi-Cosi car seat.
· Lift the Maxi-Cosi car seat straight up from the frame.
Remove the Maxi-Cosi adapters from the frame (z)
· Press the release button (z1) on the adapter. Turn the top of the adapter
EN
23