Philips SalonStraight Jade HP4665/00 Manual De Instrucciones página 10

ENGLISH
10
Never leave the appliance unattended when it is plugged in. Never
put the appliance on a surface that is not heat-resistant when it is
heating up and when it is hot.
4 When the pilot light turns green, you can adjust the heat setting
to your preference (fig. 2).
- Press the + button to increase the heat setting or press the -
button to decrease the heat setting.The display tells you which heat
setting you have selected.The pilot light turns red to indicate that
the appliance is adjusting the setting.
- The pilot light turns green when the selected heat setting has been
reached.
5 Comb or brush your hair so that it is disentangled and smooth
(fig. 3).
Use a comb to divide the hair into sections. Do not put too much hair
in one section.
Tip: it is better to section off the crown area and to straighten the hair
B
underneath first, followed by the top area.
6 Take a section that is not wider than 5 cm. Place it between the
straightening plates and press the handles of the appliance firmly
together.
7 Slide the straightener down the length of the hair in a few
seconds, from root to hair end, without stopping to prevent
overheat settinging (fig. 4).
8 Repeat this process after 20 seconds until you have achieved the
desired look.
9 Allow your hair to cool down. Do not comb or brush it before it
has cooled down, as this would ruin the hairstyle you have just
created.