Uline H-5168 Instalación página 2

EXISTING POLE MOUNTING
Use this method to mount the receptacle to an existing
pole up to 12" in diameter using the provided parts.
1. Using tin snips, cut metal straps 4" longer than the
circumference of the pole.
2. Insert the metal straps through the slots on the
mounting bracket attached to the receptacle.
(See Figure 1)
3. Insert straps through buckles and bend back excess
strap, leaving just enough space to connect the
buckles using the bolt and nut when wrapped
around the pole. (See Figure 2)
4. Wrap the straps around the pole and connect the
buckles using the bolt and nut. Use the screwdriver
and wrench to tighten the bolt. (See Figure 3)
PAGE 2 OF 9
MOUNTING
H-5170 SURFACE POLE MOUNTING
Use this method to mount the receptacles to the H-5170
Surface Mount Pole.
1. Determine position for the pole. Pre-drill four holes
into surface. (See Figure 4)
2. Install four anchor bolts into the holes and mount
pole onto the bolts. Secure with washers and nuts.
(See Figure 5)
Figure 1
3. Use the strapping kit included with the receptacle
(See Existing Pole Mounting) to attach the receptacle
to the pole or use nuts and bolts (not included) to
attach the receptacle through the pre-drilled holes.
(See Figure 6)
Figure 2
Figure 3
Figure 4 Figure 5
Figure 6
0321 IH-5168