Idiomas disponibles

Idiomas disponibles

H-8704
ALUMINUM BENCH
WITH BACK
TOOLS NEEDED
Power Drill
Two Person Assembly
Recommended
Aluminum Plank x 2
End Cap for Plank x 4
1.
Lay aluminum planks upside down on a flat surface.
Slide end caps onto each end of planks. The
pre-drilled holes of end cap should be facing up.
Use power drill and two self-tapping screws to secure
each end cap onto each end of planks.
(See Figure 1)
Figure 1
PAGE 1 OF 6
1-800-295-5510
uline.com
Socket Wrench
Hold Down Clip x 16
3/16" Self-Tapping Screw x 8
ASSEMBLY INSTRUCTIONS
Rubber Mallet
PARTS
5/16" x 1½"
Carriage Bolt x 16
5/16" Flange Nut
x 16
2. Rotate seat plank onto side. Place one leg frame at a
time on side 6" from end of seat plank. (See Figure 2)
Figure 2
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Plastic
Round Cap x 8
Galvanized Leg Frame x 2
0721 IH-8704
Tabla de contenido
loading

Resumen de contenidos para Uline H-8704

  • Página 3: Banca De Aluminio Con Respaldo

    H-8704 800-295-5510 uline.mx BANCA DE ALUMINIO CON RESPALDO HERRAMIENTAS NECESARIAS Taladro Eléctrico Llave de Dado Mazo de Caucho Se Recomienda Armar Entre Dos Personas PARTES 2 Tablas de Aluminio 8 Tapas Redondas de Plástico 16 Clips de Ajuste 16 Pernos de Cabeza Redonda de 5/16"...
  • Página 4: Continuación De Las Instrucciones De Ensamble

    Después de que la banca haya sido ensamblada, ya no habrá problema. Diagrama 4 800-295-5510 uline.mx PAGE 4 OF 6 0721 IH-8704...

Tabla de contenido