Uline H-3021 Manual De Instrucciones

π H-3021
COURTYARD FURNITURE
MOUNTINg HARDwARE
TOOls NEEDED
Drill 1/2" Masonry Bit
Washer x 4
NOTE: Best used in heavy duty, solid concrete
applications.
1. Mark the location by spacing the fixture and
marking through the mounting holes.
2. Drill the hole 1/2" deeper than wedge anchor
embedment using a masonry bit. (Hole size is
wedge anchor size). (See Figure 1)
Figure 1
3. Blow out the hole.
π
PAGE 1 OF 2
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
Hammer
ParTs
Nut x 4
MOuNTiNg iNsTrucTiONs
4. Place washer then nut on the edge of wedge
5. Hammer wedge anchor into hole deep enough
6. Tighten nut turning approximately three or
Wedge Anchor x 4
anchor (protects threads during installation).
so that threads are below surface of base material.
(See Figure 2)
Figure 2
four full turns.
Para Español, vea página 2.
0713 IH-3021